HP HDD Troubleshooting Manual page 24

6. On the Hardware Diagnostics page, select the IDE hard disk test and then click
the Run Selected Diagnostic button.
Note: The typical test time is around 2 to 5 minutes for the quick test.
7. If hard disk drive test fails, log the error code. Contact HP to obtain a replacement
drive.
8. To run the Comprehensive test, click on the Advanced Diagnostics tab, select the
IDE hard disk test and then click on the Run Selected Diagnostic button. This
test may run for over an hour depending on the hard disk drive capacity.
Note: The typical test time is around 1 minute for every 1 Gigabyte of
capacity (e.g. a 40GB drive should take approximately 40 minutes to test).
HDD Troubleshooting Guide Page 24 of 48