GE Profile PHB925SB1SS Technical Service Manual page 61

Test Mode
To enter the test mode, disconnect power to the range for 5 seconds, reconnect power, then press keys
1 and 5. The display will show tESt. A test feature is selected by pressing certain individual keys. When
selected, each test feature will remain displayed for 10 seconds, then the display will return to tESt. To exit
the test mode, touch the Clear Off pad. The test mode will automatically time out in 10 minutes.
Key Displayed for 10 Seconds
START tESt
Bake tESt
Conv tESt
Probe Probe Temperature (when plugged in)
Broil tESt
Clean Door Status
Cook Time Oven Sensor Temperature and ROM Version
Delay Start Model ID and EEPROM Checksum
Oven Light tESt
Clock All Wing-L and Wing-R LEDs ON
Timer ON 10 digits and all LEDs In Display
Timer Off All white key LEDs (except Clear/Off)
10 KEY 3 AC Input Voltage from RPSM J20
10 KEY 5 Beep Volume Level Hi-Std-Lo
RF ON/OFF RF - segment
RF - RF - L
RF + RF - H
RF Power Boil ½ segment
RR ON/OFF RR -
RR - RR - L
RR + RR - H
LF ON/OFF LF - segment
LF - LF - L
LF + LF - H
LF Simmer ½ segment in LF digit
LR ON/OFF LR - segment
LR - LR - L
LR + LR - H
LR Simmer ½ segment in LR digit
RR Melt ½ segment in RR digit
WZ .. segment in WZ digit
WZ ON/OFF
WZ Select M in WZ digit
Test Performed
Convection Fan ON (CW)
Bake Element On With DLB
Convection Element On With DLB
Probe Temperature
Broil Element On With DLB
Locks, then Unlocks The Door
Convection Fan On (CCW)
Oven Light On
Operates All Wing-L and Wing-R LEDs
L1 to L2 Voltage at RPSM J20 Shown
Sounds Beep Volume Levels
- Segment, Element ON, Hot Cooktop RF LED ON
L Digit ON
H Digit ON
½ segment ON
- Segment ON
L Digit ON, Hot Cooktop RR LED ON
H Digit ON
- Segment ON, Hot Cooktop LF LED ON
L Digit ON
H Digit ON
½ segment ON
- Segment ON
L Digit ON, Hot Cooktop LR LED ON
H Digit ON, 4 Hot Cooktop LEDs ON
½ segment ON
½ segment ON
WZ .. segment ON
M Digit ON
– 61 –
(Continued next page)