Aluminum Plate; Bridge Board; Cooktop Components - GE Profile PHB925SB1SS Technical Service Manual

Aluminum Plate

To remove the aluminum plate:
1. Remove the cooktop assembly. (See
.)
Assembly
2. Place the cooktop topside down on a protective
surface.
3. Remove the seven 3/8-in. hex-head nuts and
spacers.
4. Slide the seven carriage bolts out of the keyed
slots in the cooktop.

Cooktop Components

Cooktop
Carriage Bolt
5. Lift the aluminum plate from the cooktop.
Note: When installing the aluminum plate to the
cooktop, be sure to install spacers with the shoulder
toward cooktop.

Bridge Board

The bridge board is located under the cooktop and
attached to the aluminum plate with 4 compression
pins. Three wire harnesses are connected to the
board. It is necessary to remove the aluminum plate
to access the bridge board. (See
– 49 –
Shoulder
Aluminum Plate.)
Disconnect