Chicago Electric 65712 Set Up And Operating Instructions Manual
  1. Manuals
  2. Brands
  3. Chicago Electric Manuals
  4. Garage Door Opener
  5. 65712
  6. Set up and operating instructions manual
Chicago Electric 65712 Set Up And Operating Instructions Manual

Chicago Electric 65712 Set Up And Operating Instructions Manual

Garage door opener with dual remotes
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
GaraGe door opener
set up and operatinG instructions
distributed exclusively by harbor Freight tools
Visit our website at: http://www.harborfreight.com
read this material before using this product.
Failure to do so can result in serious injury.
saVe this manual.
©
Copyright
2008 by Harbor Freight Tools
contained herein may be reproduced in any shape or form without the express written consent of
Harbor Freight Tools. Diagrams within this manual may not be drawn proportionally. Due to continuing
improvements, actual product may differ slightly from the product described herein. Tools required for
assembly and service may not be included.
For technical questions or replacement parts, please call 1-800-444-3353.
With dual remotes
3491 Mission Oaks Blvd., Camarillo, CA 93011
®
. All rights reserved. No portion of this manual or any artwork
65712
®
.

Advertisement

Table of Contents
loading

Summary of Contents for Chicago Electric 65712

  • Page 1 GaraGe door opener With dual remotes 65712 set up and operatinG instructions ® distributed exclusively by harbor Freight tools 3491 Mission Oaks Blvd., Camarillo, CA 93011 Visit our website at: http://www.harborfreight.com read this material before using this product. Failure to do so can result in serious injury.

  • Page 2: Table Of Contents

    ..8 adJustment instructions . 19 maintenance and serVicinG ....... 27 please read the FolloWinG careFullY ..27 troubleshootinG ....28 parts list ......... 29 assemblY diaGram ....30 SKU 65712 For technical questions, please call 1-800-444-3353. Page 2...

  • Page 3: Important Safety Information

    Un- hazardous situation which, if modified Plugs and matching Outlets not avoided, could result in will reduce risk of electric shock. minor or moderate injury. SKU 65712 For technical questions, please call 1-800-444-3353. Page 3...
  • Page 4 Garage door opener. may affect the power equipment’s SKU 65712 For technical questions, please call 1-800-444-3353. Page 4...

  • Page 5: Specific Safety Warnings

    This product is provided with a Trans- The “safety reverse system test” is former and Power Supply Cord of very important. The Garage Door special design which, if damaged, Opener MUST reverse on contact SKU 65712 For technical questions, please call 1-800-444-3353. Page 5...

  • Page 6: Grounding

    OSHA require- instructions. ments and complies with the applica- ble standards of Underwriters Labo- ratories, Inc., the Canadian Standard Association, and the National Electri- SKU 65712 For technical questions, please call 1-800-444-3353. Page 6...

  • Page 7: Extension Cords

    Make sure the Extension Cord is properly wired and in good electrical condition. Always replace a damaged Extension Cord or have it repaired by a qualified electrician before using it. Protect the Extension Cords from SKU 65712 For technical questions, please call 1-800-444-3353. Page 7...

  • Page 8: Specifications

    If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible. reV 08j SKU 65712 For technical questions, please call 1-800-444-3353. Page 8...
  • Page 9 • For additional accessory (not included) ground connection. • terminal #4: For additional accessory (not included). • terminal #5: For additional 24 volt power source. • terminal #6: Additional terminal. SKU 65712 For technical questions, please call 1-800-444-3353. Page 9...
  • Page 10 (43): manual release rope & handle (35): rail (49): curved door arm (59): chain (46): straight door arm (28): hanging bracket (50): door bracket (9): power cord (54): header bracket SKU 65712 For technical questions, please call 1-800-444-3353. Page 10...
  • Page 11 Rail. Connect a Rail by sliding a Rail Brace onto the next Rail. Tap the Rail assembly on a piece of flat scrap wood until all Rails are flush. Repeat this proce- dure with the remaining Rails. (see Figure e.) SKU 65712 For technical questions, please call 1-800-444-3353. Page 11...
  • Page 12 FiGure G tappinG screW (73) sprocket coVer housinG (31) (72) Place the Sprocket Cover (72) on top of the Housing (31) and secure with three Tapping Screws (73). (see Figure G.) SKU 65712 For technical questions, please call 1-800-444-3353. Page 12...
  • Page 13 Open the door to the highest point of travel. Draw an intersecting horizontal line on the wall 2” above the high point to provide travel clearance for the top edge of the door. (see Figure i.) SKU 65712 For technical questions, please call 1-800-444-3353. Page 13...
  • Page 14 Drill two 3/16” pilot holes and fasten the Header Bracket with two Hex Tap- ping Screws (55). For a concrete ceiling mount, use the two Concrete Anchors (56) provided. (see Figures i and J.) SKU 65712 For technical questions, please call 1-800-444-3353. Page 14...
  • Page 15 Rail on the board. NOTE: If the raised garage door hits the unit’s Trolley (45), pull down on the Trolley Release Arm to disconnect the inner and outer Trolley sec- SKU 65712 For technical questions, please call 1-800-444-3353. Page 15...
  • Page 16 Center the Door Bracket at the top inside surface of the garage door. Then secure the Door Bracket to the door using two Hex Tapping Screws (53). (see Figure n.) SKU 65712 For technical questions, please call 1-800-444-3353. Page 16...
  • Page 17 (see Figure o, illustration a.) Figure o, Illustration B. For sectional door installation, connect according to SKU 65712 For technical questions, please call 1-800-444-3353. Page 17...
  • Page 18 120 volt, grounded, electrical outlet. Press the Button of the Door Control assembly to open or close the garage door. Press again to stop the door while it is moving. (see Figure p.) SKU 65712 For technical questions, please call 1-800-444-3353. Page 18...
  • Page 19 To erase all Remote Control (75) codes, press and hold the “LEARN” Button. The Digital Display will indicate “ ” before indicating “h”. The codes are now erased when the Digital Display flashes with “h”. (see Figure Q, Illustration D.) SKU 65712 For technical questions, please call 1-800-444-3353. Page 19...
  • Page 20 OPEN position to store the data. The Digital Display will indi- cate “1” which will glow steadily. Now the setting for the open limit is finished. (see Figures t and u.) SKU 65712 For technical questions, please call 1-800-444-3353. Page 20...
  • Page 21 If only the OPEN/CLOSE limit is set, the function of automatic closing and the Light Switch is not available in the unit, and the default Open/Close Force is “4” level. SKU 65712 For technical questions, please call 1-800-444-3353. Page 21...
  • Page 22 If no other setting is to be programmed right now, press the “set” Button. The Digital Display will indicate “h”. Now the open force adjust- ment is finished. (see Figures FF and GG.) SKU 65712 For technical questions, please call 1-800-444-3353. Page 22...
  • Page 23 If no other setting is to be programmed right now, press the “set” Button. The Digital Display will indicate “h”. Now the close force setting is fin- ished. (see Figures mm, nn, and oo.) SKU 65712 For technical questions, please call 1-800-444-3353. Page 23...
  • Page 24 The Digital Display will indicate a steadily glowing “5”. The unit is ready for setting another parameter. If no other setting is to be programmed right now, press SKU 65712 For technical questions, please call 1-800-444-3353. Page 24...
  • Page 25 23. If there is no photocell detector installed, press the “doWn” button and the dis- play will show a “0”. (see Figure YY.) Press the “set” button when finished setting the photocell mode. reV 08l SKU 65712 For technical questions, please call 1-800-444-3353. Page 25...
  • Page 26 20 inches when attempting to raise. light bulb will automatically illuminate when the garage door is activated and will shut off after three minutes with no control activity. SKU 65712 For technical questions, please call 1-800-444-3353. Page 26...

  • Page 27: Maintenance And Servicing

    REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING Reverse” test after any adjustment. OUT OF HIS OR HER INSTALLATION OF Refer to manual for instructions. REPLACEMENT PARTS THERETO. SKU 65712 For technical questions, please call 1-800-444-3353. Page 27...

  • Page 28: Troubleshooting

    Release Handle straight down. The next time the Opener is activated, the Trolley will reconnect. Follow all safety precautions whenever diagnosing or servicing the Garage door opener. disconnect power supply before service. SKU 65712 For technical questions, please call 1-800-444-3353. Page 28...

  • Page 29: Parts List

    If product has no serial number, record month and year of purchase instead. note: Some parts are listed and shown for illustration purposes only, and are not avail- able individually as replacement parts. SKU 65712 For technical questions, please call 1-800-444-3353. Page 29...

  • Page 30: Assembly Diagram

    SKU 65712 For technical questions, please call 1-800-444-3353. Page 30...
  • Page 31 This warranty gives you specific legal rights and you may also have other rights which vary from state to state. 3491 Mission Oaks Blvd. • PO Box 6009 • Camarillo, CA 93011 • (800) 444-3353 reV 08j SKU 65712 For technical questions, please call 1-800-444-3353. Page 31...

Table of Contents