●
USB board (see
●
Power connector cable (see
●
Display assembly (see
NOTE:
When replacing the system board, be sure that the following components are removed from
the defective system board and installed on the replacement system board:
●
Memory module (see
●
RTC battery (see
RTC battery on page
●
Fan/heat sink assembly (see
●
Processor (see
Processor on page
Remove the system board:
1.
Disconnect the optical drive connector cable from the system board.
2.
Remove the Phillips PM2.5×6.0 screw (1) that secures the system board to the base enclosure.
3.
Lift the right side of the system board (2) until it rests at an angle.
USB board on page
65)
Power connector cable on page
Display assembly on page
Memory module on page
81)
Fan/heat sink assembly on page
89)
66)
68)
47)
83)
Component replacement procedures
77