HP 430 Maintenance And Service Manual page 77

5. Disconnect the WLAN module antenna cables from the WLAN module (see
on page 44).
6. Remove the following components:
●
Hard drive (see
●
Keyboard (see
●
Top cover (see
●
Speakers (see
●
USB board (see
●
Power connector cable (see
Remove the display assembly:
1. Disconnect the display panel cable (1) from the system board.
2. Release the wireless antenna cables from the clips (2) built into the base enclosure.
CAUTION: Support the display assembly when removing the following screws. Failure to
support the display assembly can result in damage to the display assembly and other
computer components.
3. Remove the four Phillips PM2.5×6.0 screws (3) that secure the display assembly to the computer.
4. Remove the display assembly (4).
Hard drive on page 48)
Keyboard on page 53)
Top cover on page 56)
Speakers on page 63)
USB board on page 65)
Power connector cable on page
WLAN module
66)
Component replacement procedures
69