Power Connector Cable - HP 430 Maintenance And Service Manual

Reverse this procedure to install the USB board.

Power connector cable

Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
●
Memory module/wireless module compartment cover (see
●
Hard drive (see
●
Keyboard (see
●
Top cover (see
●
Speakers (see
●
USB board (see
Remove the power connector cable:
1. Close the computer.
2. Turn the computer upside down, with the front toward you.
3. Disconnect the power connector cable (1) from the system board.
66 Chapter 4 Removal and replacement procedures
Battery on page 43), and then remove the following components:
Hard drive on page 48)
Keyboard on page 53)
Top cover on page 56)
Speakers on page 63)
USB board on page 65)
Spare part number
641394-001
WLAN module on page 44)