Speakers - HP 430 Maintenance And Service Manual

Speakers

Description
Speaker Kit (includes left and right speakers and cable)
Before removing the speakers, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
●
Memory module/wireless module compartment cover (see
●
Hard drive (see
●
Keyboard (see
●
Top cover (see
Remove the speakers:
1. Disconnect the speaker cable (1) from the system board.
2. Release the speaker cables (2) from the clips built into the base enclosure.
3. Release the ZIF connector to which the USB board cable is attached, and then disconnect the USB
cable (3) from the system board.
4. Remove the two Phillips PM2.5×6.0 screws (4) and the Phillips PM2.0×9.0 screw (5) that secure
the speakers to the computer.
Battery on page 43), and then remove the following components:
Hard drive on page 48)
Keyboard on page 53)
Top cover on page 56)
Spare part number
645978-001
WLAN module on page
Component replacement procedures
44)
63