Top Cover - HP 430 Maintenance And Service Manual

Top cover

NOTE: The top cover spare part kit includes the TouchPad and TouchPad cable.
Description
In pewter finish for use with all computer models
In charcoal gray finish for use only with Compaq 435 and Compaq 436 computer models
Before removing the top cover, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
●
Memory module/wireless module compartment cover (see
●
Hard drive (see
●
Keyboard (see
NOTE: When replacing the top cover, be sure that the following components are removed from
the defective top cover and installed on the replacement top cover:
●
Power button board and cable (see
●
TouchPad button board and cable (see
Remove the top cover:
1. Close the computer.
2. Turn the computer upside down, with the front toward you.
56 Chapter 4 Removal and replacement procedures
Battery on page 43), and then remove the following components:
Hard drive on page 48)
Keyboard on page 53)
Power button board on page
TouchPad button board on page
Spare part number
646667-001
645963-001
WLAN module on page
60)
61)
44)