Return The Extender To Its Factory Default Settings; Use The Restore Factory Settings Button - NETGEAR WN2500RPv2 User Manual

Return the Extender to Its Factory Default Settings

Under some circumstances (for example, if you have lost track of the changes that you made
to the extender settings), you might want to erase the configuration and reset it to factory
default settings.
To reset the extender to factory default settings, you can use either the Restore Factory
Settings button on the rear panel or the Erase function. However, if you have lost the
password to access the extender, you must use the Restore Factory Settings button.
For a list of factory default settings, see

Use the Restore Factory Settings Button

CAUTION:
This process erases any settings that you have configured in the extender.

To reset the extender to factory default settings:
1. Insert a straightened paper clip into the hole of the Restore Factory Settings button
and hold it for about seven seconds.
2. Release the button.
The extender resets and restarts. This process takes about one minute.
N600 WiFi Range Extender
Factory Default Settings
Restore Factory Settings button
Maintain and Monitor the Extender
71
on page 85.