Log In To The Extender After Initial Setup - NETGEAR WN2500RPv2 User Manual

Log In to the Extender After Initial Setup

You can log in to the extender to view or change the extender's settings.
If you connect to the extender before it has been set up, the browser automatically goes to
http://www.mywifiext.net and displays the NETGEAR genie Smart Setup screens, which step
you through the setup process. For more information, see
and Use Smart Setup
Setup on page 22.

To log in to the extender after initial setup:
1. On your computer, launch an Internet browser such as Mozilla Firefox or Microsoft
Internet Explorer.
2. In the address field of your browser, enter www.mywifiext.net.
You are prompted to enter a user name and password.
3. Type admin for the user name and password for the password.
Note: NETGEAR recommends that you set a more secure password after you
log in. For more information, see
The Status screen displays (see the following figure). Menu selections display on the left.
The Status screen shows the current settings for the extender. The firmware version
displays below the language menu.
For more information about the Status screen, see
of the Extender
For information about upgrading firmware, see
4. To change your language, select a language from the menu in the top right of the screen.
By default, the language selection is Auto, which means that the extender uses the
language that it detects from the browser that you use.
N600 WiFi Range Extender
on page 15 or Access the Extender over Ethernet and Use Smart
on page 74.
Manage the Extender Network and Security Settings
Access the Extender over WiFi
Change the Password
View the Status and Traffic Statistics
Update the Firmware
31
on page 33.
on page 73.