Backup And Recovery; Creating Recovery Discs In Windows Vista - HP Compaq 6520s Maintenance And Service Manual

8

Backup and recovery

Creating recovery discs in Windows VIsta

After setting up the computer for the first time, be sure to create a set of recovery discs of the full
factory image. The recovery discs are used to start up (boot) the computer and recover the operating
system and software to factory settings in case of system instability or failure.
Note the following guidelines before creating recovery discs:
●
Use any of the following types of discs: CD-R, DVD+R, DVD+R DL, DVD-R, or DVD-R DL
(purchased separately). The discs you use will depend on the type of optical drive installed in
your computer. Because DVDs store more information than CDs, DVDs and DVDs with double-
layer (DL) support reduce the number of discs required.
NOTE:
the HP Backup & Recovery Manager software.
● The computer must be connected to AC power during the process.
●
Only one set of the recovery discs can be created per computer.
●
Number each disc before inserting it into the optical drive of the computer.
●
If necessary, you can cancel the disc creation before you have finished creating the recovery
discs. The next time you select Create a set of recovery discs (Recommended), you will be
prompted to continue the disc creation.
To create a set of recovery discs:
1. Select Start > All Programs > HP Backup & Recovery > Backup & Recovery Manager.
2. Click Next.
3. Click Create a set of recovery discs (Recommended), and then click Next.
4. Follow the on-screen instructions.
116 Chapter 8 Backup and recovery
Read-write discs, such as CD-RW, DVD+RW, and DVD-RW, are not compatible with