Unmodified plugs and matching out- minor or moderate injury. lets will reduce risk of electric shock. SKU 66133 For technical questions, please call 1-800-444-3353. Page 2...
Page 3
Disconnect the plug from the safety goggles. Safety equipment power source before making any such as a NIOSH-approved dust adjustments, changing accesso- mask/respirator, non-skid safety ries, or storing power tools. Such SKU 66133 For technical questions, please call 1-800-444-3353. Page 3...
This will ensure that the safety of the lead to motor failure and possibly power tool is maintained. damage. Never place your hands or any part of your body or clothing inside the Up- REV 09i SKU 66133 For technical questions, please call 1-800-444-3353. Page 4...
Page 5
In addition, people with structions discussed in this instruction pacemakers should: manual cannot cover all possible con- • Avoid operating alone. ditions and situations that may occur. REV 09i SKU 66133 For technical questions, please call 1-800-444-3353. Page 5...
If you are using one Extension Cord tool should electrically malfunction for more than one tool, add the or break down, grounding provides a nameplate amperes and use the sum REV 09i SKU 66133 For technical questions, please call 1-800-444-3353. Page 6...
Page 7
150% of the rated amperes. To prevent disconnection of the tool’s Power Cord (37) from the Extension Cord during operation, make a knot in the two cords. (See Figure A.) REV 09b, 09i SKU 66133 For technical questions, please call 1-800-444-3353. Page 7...
Secure the Wheels to the Axle us- ing one Self Locking Hex Nut (34) for each Wheel. Then insert one Wheel Cap (41) on each Wheel. (See Figure C.) REV 09i SKU 66133 For technical questions, please call 1-800-444-3353. Page 8...
Page 9
Housing (11). Attach the Supports STuD pLATE b and Lower Housing using two Stud Plate A’s (29) and six Self Locking Hex Nuts (7). (See Figure D.) SELF LOCKIng HEx nuT REV 09i SKU 66133 For technical questions, please call 1-800-444-3353. Page 9...
Page 10
Plates (6), and eight Self Locking Hex Nuts (7). Make sure to place the Screw heads on the inside with the Plates and Nuts on the outside. (See Figure g.) FIguRE H REV 09i SKU 66133 For technical questions, please call 1-800-444-3353. Page 10...
Page 11
(See Figure I.) FIguRE I THREAD EnDS muST THROugH EQuAL LEngTH HOLE InSERT THROugH FERRuLE CuTTIng HOLE CORD (20) SpInnER HEAD (19) bOTH EnDS muST bE EVEn REV 09b, 09i SKU 66133 For technical questions, please call 1-800-444-3353. Page 11...
Make sure the tool is located on a dry, level surface. Make sure the Leaf Eater/Shredder is located on a dry, level surface. REV 09i SKU 66133 For technical questions, please call 1-800-444-3353. Page 12...
Page 13
Upper Housing (2) area when move it to the medium position, etc.) the tool is plugged into an electrical outlet. (See Figure K.) FIguRE L FIguRE K REV 09i SKU 66133 For technical questions, please call 1-800-444-3353. Page 13...
WHEN OPERATION PRODUCES SIGNIFICANT AMOUNTS OF DUST: The Air Filter Housing (13) is located on the side of the Lower Housing (11) by the ON/Off Switch (38). Remove REV 09i SKU 66133 For technical questions, please call 1-800-444-3353. Page 14...
If product has no serial number, record month and year of purchase instead. note: Some parts are listed and shown for illustration purposes only, and are not avail- able individually as replacement parts. REV 09i SKU 66133 For technical questions, please call 1-800-444-3353. Page 15...
BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO. REV 09i SKU 66133 For technical questions, please call 1-800-444-3353. Page 16...
Page 18
This warranty gives you specific legal rights and you may also have other rights which vary from state to state. 3491 Mission Oaks Blvd. • PO Box 6009 • Camarillo, CA 93011 • (800) 444-3353 REV 09i SKU 66133 For technical questions, please call 1-800-444-3353. Page 18...