Always lock up tools and keep out of reach of children. Do not force tool. It will do the job better and more safely at the rate for which it was intended. Do not use inappropriate attachments in an attempt to exceed the tool capacity. SKU 42564 Page 2...
Page 3
It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator. SKU 42564 Page 3...
The Battery (21) does not come charged from the factory. Charge before using. (Refer to top photo on next page.) Charging room temperature: 50 F - 104 Plug the Battery Charger (A) into an electrical outlet. REV 10/03 SKU 42564 Page 4...
Hold the Chuck Sleeve firmly while turning the Chuck (17) counterclockwise until the opening is large enough to accept the drill bit or screw driver bit. Insert bit and turn Chuck (17) clockwise until it is locked on the bit. Reverse procedures to remove a bit. SKU 42564 Page 5...
Set the Gear Box (14) for normal drilling or hammer (impact) drilling. The impact drill setting (indicated by a hammer symbol) is typically used for drilling cement or other hard and brittle materials. Press (and hold) the Switch (16) to turn drill On. SKU 42564 Page 6...
Recharge battery periodically when not in use. Using a rag and light oil, wipe drill bits and other steel parts to keep them from rusting. Parts List REV 10/03 SKU 42564 Page 7...
SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO. SKU 42564 Page 8...