d.
Keyboard (see
e.
Top cover (see
f.
Speakers (see
g.
System board (see
Remove the power connector cable:
1.
Release the display panel cable (1) from the routing channel built into the base enclosure.
2.
Release the power connector cable (2) from the routing channel built into the base enclosure.
3.
Release the power connector (3) from the molding built into the base enclosure.
4.
Remove the power connector cable.
Reverse this procedure to install the power connector cable.
Keyboard on page
52)
Top cover on page
55)
Speakers on page
64)
System board on page
67)
Component replacement procedures
79