Using Hp Pc Hardware Diagnostics (Uefi) (Select Models Only); Downloading Hp Pc Hardware Diagnostics (Uefi) To A Usb Device - HP 340 G1 Maintenance And Service Manual

Using HP PC Hardware Diagnostics (UEFI) (select models only)

HP PC Hardware Diagnostics is a Unified Extensible Firmware Interface (UEFI) that allows you to run
diagnostic tests to determine if the computer hardware is functioning properly. The tool runs outside of
the operating system to isolate hardware failures from issues that may be caused by the operating
system or other software components.
To start HP PC Hardware Diagnostics UEFI:
1. Turn on or restart the computer, quickly press esc, and then press f2.
The BIOS searches three places for the diagnostic tools, in the following order:
a. Connected USB drive
NOTE:
Downloading HP PC Hardware Diagnostics (UEFI) to a USB device on page
b. Hard drive
c. BIOS
2. Click the type of diagnostic test you want to run, and then follow the on-screen instructions.
NOTE:

Downloading HP PC Hardware Diagnostics (UEFI) to a USB device

NOTE:
Instructions for downloading HP PC Hardware Diagnostics (UEFI) are provided in English
only.
1.
Go to http://www.hp.com.
2. Click Support & Drivers, and then click the Drivers & Dowloads tab.
3. Enter the product name in the text box, and then click Go.
4.
Select your computer model, and then select your operating system.
5. In the Diagnostic section, click HP UEFI Support Environment.
– or –
Click Download, and then select Run.
96 Chapter 7 Computer Setup (BIOS)
To download the HP PC Hardware Diagnostics (UEFI) tool to a USB drive, see
If you need to stop a diagnostic test while it is running, press esc.
96.