HP Compaq 325 Maintenance And Service Manual page 97

3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the service door (see
6. Remove the palm rest (see
7. Remove the keyboard (see
8. Remove the top cover (see
Remove the display on 39.6-cm (15.6-in) computers:
1. Orient the computer in its normal position, face up with the display open as far as it will
comfortably go.
CAUTION: Support the display assembly when removing the retaining screws. Failure to
support the display assembly can result in damage to the display assembly and other computer
components.
2. Disconnect the display cable (1) and the microphone cable (2) from the system board.
3. Release the WLAN cables from the cable run (3), being careful when pulling them through the
opening near the hard drive.
4. Remove eight Torx M2.5×6.0 screws (1) that secure the display to the base enclosure. Be careful
of the grounding cable (2) that is secured by one of the hinge retaining screws.
Battery on page 51).
Service door on page
Palm rest on page 70).
Keyboard on page 73).
Top cover on page 77).
52).
Component replacement procedures
89