Switch Cover - HP Compaq 2510p Maintenance And Service Manual

7. Remove the two Phillips PM2.0×3.0 screws (1) that secure the optical drive bracket to the optical
drive.
8. Remove the optical drive bracket (2).
Reverse this procedure to reassemble and install the optical drive.

Switch cover

Description
Switch cover (includes LED board and cable)
Before removing the switch cover, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
Remove the switch cover:
1. Turn the computer right-side up, with the front toward you.
2. Open the computer as far as possible.
Battery on page 41).
Spare part number
451717-001
Component replacement procedures 57