Chicago Electric 68988 Owner's Manual & Safety Instructions page 12

adjusting Depth
1. Set the Base flat against the
edge of the workpiece.
2. Loosen the Depth Lock Lever to allow
the depth of cut to be adjusted.
3. Use the Depth Scale located behind the
housing to set depth of cut.
WaRnInG! to reduce the risk of
serious injury, adjust the depth
of cut to just barely clear the
workpiece and remove shavings.
4. After adjustment, tighten the
Depth Lock Lever.
WaRnInG! tighten Depth
lock lever before use.
adjusting Bevel
1. Loosen the Bevel Lock Lever to allow
the angle of cut to be adjusted.
2. Use the Bevel Scale to set the desired angle.
3. After adjustment, tighten the
Bevel Lock Lever.
WaRnInG! tighten Bevel
lock lever before use.
Installing and adjusting Fence
1. to install: Remove Fence Lock Nut,
slide ruler through slots, then replace
Fence Lock Nut.
2. to adjust: Loosen Fence Lock Nut and slide
the Fence to the desired width of cut.
note: The ruler on the fence shows
the approximate width of cut.
3. If needed, remove the Fence
entirely. Otherwise, tighten the
Fence Lock Nut after adjustment.
WaRnInG! tighten Fence
lock nut before use.
Page 12 For technical questions, please call 1-888-866-5797.
Depth
Scale
Figure D
Bevel
Bevel
lock
Scale
lever
Figure E
Fence lock nut
Slot
(not visible)
(not visible)
Slot
Figure F
Depth
lock
lever
Fence
Item 68988