Reading The Busy Light - HP 2240 Owner's Manual

Reading the Busy Light

The CD-ROM busy light shows the status of the drive during the self
test and during activity with the host system.
The CD-ROM drive performs the self test when one of the following
happens:
You load a disc and close the Disc Tray.
You turn on the workstation with a disc already loaded in the
CD-ROM drive.
For the self test, the busy light operates in the following sequence:
1. Light On – The busy light goes on when the disc loads into
the drive.
2. Light Flashing – The light flashes six times while a read test
is performed on the disc.
3. Light Off – The light goes off when the self test is com-
plete.
The busy light stays on after the self test when one of the following
conditions exist:
A defective disc
A disc insertion error (for example, an upside-down disc)
No disc present
The busy light goes off when one of the following conditions exist:
A CD-ROM drive power failure exists.
The drive is idle on the SCSI bus.
The busy light flashes during normal activity with the system.
2-19