Card Reader Board - HP PROBOOK 4530S Maintenance And Service Manual

Card reader board

Description
Card reader board for use in 4530s models
Card reader board for use in 4730s models
Before removing the card reader, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Bottom door (see
b. Optical drive (see
c. Keyboard (see
d. Top cover (see
Remove the card reader:
1. Position the top cover upside-down with the front toward you.
2. Remove the tape that secures the cable to the Touchpad button board (1).
3. Disconnect the cable from the connector on the Touchpad button board (2).
4. Remove the two Phillips PM2.5×5.0 screws (3) that secure the card reader board to the top
cover.
NOTE:
70 Chapter 4 Removal and replacement procedures
Battery on page
Bottom door on page
Optical drive on page
Keyboard on page
Top cover on page
Screw position may vary.
47).
49).
50)
63)
65)
Spare part number
646292-001
646293-001