HP PAVILION DV6 Maintenance And Service Manual page 54

4. Use the Mylar tab 1 to lift the hard drive up, and then slide it to the left 2 to release it from the hard drive bay.
5. Disconnect the hard drive cable 3 from the system board.
6. Remove the hard drive from the hard drive bay.
7. If it is necessary to replace the hard drive bracket or any of the hard drive bracket components, remove the
following:
a. Hard drive connector cable 1
b. Four rubber isolators 2
c. Four Phillips PM3.0×3.5 screws 3 that secure the hard drive bracket rails and Mylar cover to the hard
drive.
d. Left and right hard drive bracket rails with Mylar cover tabs 4.
Reverse this procedure to reassemble and install the hard drive.
Maintenance and Service Guide
Removal and replacement procedures
4–15