Digital Media Assembly - HP PAVILION 311 Maintenance And Service Manual

Removal and replacement procedures

Digital media assembly

Description
Digital media assembly (includes cable)
Before removing the digital media assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the accessory compartment cover (see
6. Remove the hard drive (see
7. Remove the keyboard (see
8. Remove the top cover (see
Remove the digital media assembly:
1. Turn the computer right-side up, with the front toward you and the display open as far as possible.
2. Disconnect the LIF digital media assembly cable 1.
3. Remove the Phillips PM2.0×4.0 screw 2 that secures the digital media assembly to the base enclosure.
4. Remove the digital media assembly 3.
Reverse this procedure to install the digital media assembly.
4–30
"Battery" on page 4-7).
"WLAN module" on page
"Hard drive" on page
"Keyboard" on page 4-21).
"Top cover" on page 4-24).
4-18).
Spare part number
580065-001
4-9).
Maintenance and Service Guide