Figure 2-25. Removing The Audio Pca - HP NX9010 Service Manual

3. Disconnect the audio PCA cable from the motherboard.
4. Remove the audio PCA cable from the clip on the bottom case.
5. Remove the two M2.0×3.0 mm flathead screws that secure the audio PCA shield to the bottom
case.
6. Remove the audio PCA shield.
7. Remove the M2.0×3.0 mm flathead screw that secures the audio PCA to the bottom case.
8. Remove the audio PCA.
Reassembly Note
Caution
Use care when handling the audio PCA cable. Damaging the cable can degrade notebook
performance.
•
Make sure you route the audio PCA cable into the clip on the bottom case.
Service Manual

Figure 2-25. Removing the Audio PCA

Removal and Replacement 2-39