HP Compaq Mini 110 Maintenance And Service Manual page 87

5. If your device has WWAN capability, remove the SIM (see
6. Remove the following components:
a. Keyboard (see
b. Hard drive or solid-state drive (see
c. Top cover (see
Remove the display assembly:
1. Release the tape securing the WWAN antennas (1).
2. Disconnect the following cables from the system board:
(2) Display panel cable
(3) Microphone cable
(4) Speaker cable
(5) WLAN cables
(6) WWAN cables (select models only)
CAUTION: Support the display assembly when removing the following screws. Failure to support
the display assembly can result in damage to the display assembly and other device components.
3. Remove the 4 Phillips PM2.5×5.0 screws (1) that secure the display assembly to the device.
NOTE: One screw on the left hinge (2) also secures the display panel cable ground strap.
Keyboard on page 48)
Mass storage devices on page
Top cover on page 57)
SIM on page 45).
54)
Component replacement procedures 77