Power Connector - HP MINI 210 Maintenance And Service Manual

Power connector

Description
Power connector
Before removing the power connector, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the service access cover (see
6. Disconnect the hard drive cable from the system board (see
7. Disconnect the WLAN antenna cables from the WLAN module (see
8. Disconnect the WWAN antenna cables from the WWAN module (see
on page
9. Remove the following components:
a. Keyboard (see
b. Top cover (see
c. Display assembly (see
d. System board (see
Remove the power connector:
1. Loosen the tabs (1) that secure the power connector to the base enclosure.
66 Chapter 4 Removal and replacement procedures
Battery on page
41).
Keyboard on page
Top cover on page
Display assembly on page
System board on page
37).
Service access cover on page
Hard drive on page
48).
54).
59).
61).
Spare part number
646095-001
38).
45).
WLAN module on page
WWAN module
39).