3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery cover and battery (see
following components:
a.
Hard drive (see
b.
Memory module/wireless module compartment cover (see
c.
Top cover (see
Remove the solid-state drive connector board:
1.
Disconnect the Bluetooth module cable (1) from the solid-state drive connector board.
2.
Release the ZIF connector to which the solid-state drive connector board cable is attached,
and then disconnect the cable (2) from the system board.
3.
Release the grounding tape (3) that secures the solid-state drive connector board cable to the
base enclosure.
4.
Remove the Phillips PM2.0×2.82 screw (4) that secures the solid-state drive connector board to
the base enclosure.
5.
Remove the solid-state drive connector board (5) and cable.
Reverse this procedure to install the solid-state drive connector board and cable.
Battery on page
Mass storage device on page
Top cover on page
49)
36), and then remove the
38)
WLAN module on page
Component replacement procedures
41)
57