Remove the Bluetooth module:
1.
Disconnect the Bluetooth module cable (1) from the solid-state drive connector board.
2.
Release the grounding tape (2) that secures the Bluetooth module to the base enclosure.
3.
Release the Bluetooth module cable (3) from the routing clips and channel built into the
base enclosure.
4.
Release the Bluetooth module (4) from the retention clip built into the base enclosure.
5.
Remove the Bluetooth module and cable.
Reverse this procedure to install the Bluetooth module and cable.
Solid-state drive connector board
Description
For use only with computer models equipped with an mSATA solid-state drive
For use only with computer models not equipped with an mSATA solid-state drive
Before removing the solid-state drive connector board, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
56
Chapter 4 Removal and replacement procedures
Spare part number
654171-001
661706-001