Preparing The Notebook For Disassembly; 6-Cell Battery Pack - HP COMPAQ NC4200 Maintenance And Service Manual

6.3 Preparing the Notebook for
Disassembly
Before you begin any removal or installation procedures:
1. Shut down the notebook. If you are unsure whether the
notebook is off or in hibernation, turn the computer on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the notebook.
3. Disconnect the power cord.

6-cell battery pack

4. Remove the battery pack by following these steps:
a. Turn the notebook upside down with the rear panel
b. Slide the battery release latch 1 toward you. (The left side
c. Lift the left side of the battery pack and swing it to the
Removing the Battery Pack
Reverse the above procedure to install the battery pack.
Maintenance and Service Guide
Battery Pack Spare Part Number Information
toward you.
of the battery pack disengages from the notebook.)
right 2 to remove it.
Removal and Replacement Procedures
383510-001
6–5