Step 4: Set Up The Software; Step 5: Create Recovery Discs (Recommended) - HP 435816-001 Getting Started

First-time setup

Step 4: Set up the software

After the computer is turned on, it will go through software setup.
Follow the on-screen instructions to set up the software. Note the
following points:
After you respond to the setup prompt, you must complete
the entire setup process without interruption. Setup time
varies.
During software setup, the computer may pause periodically
for several minutes. These normal pauses are indicated by an
hourglass icon.
CAUTION: If you are prompted to select an operating system
Ä
language, choose carefully. On some models, the languages that you
do not choose are deleted from the system and cannot be restored
during software setup.
To register the operating system and the computer during software
setup, the computer must be connected by an RJ-45 (network)
cable to an existing network that has access to the Internet. If you
do not register during software setup, you can do so at any time
after software setup is complete. For more information about
connecting to the Internet, refer to Appendix A, "Connect to the
Internet from your home," in this guide.
Step 5: Create recovery discs
(recommended)
You can create a set of recovery discs of your full factory image
using HP Backup & Recovery Manager. You can use the recovery
discs to start up (boot) the computer and restore the operating
system and software programs to factory settings in case of
system failure or instability.
Refer to Appendix B, "Backup and recovery," for detailed
instructions.
1–8 Getting Started