Displaying The Current Memory Configuration; Memory Information Example - HP 744 Hardware User Manual

NOTE:
Displaying the Current Memory Configuration
The memory command shows the memory configuration table.
To display the current memory configuration for your system, from the
Information Menu of the boot console interface, follow the directions in
"Accessing the Boot Console Interface" earlier in this chapter. Once you are
in the Boot Console Interface Main Menu, type:
Main Menu: Enter command > information
This places you in the Information Menu. From here type:
Information Menu: Enter command > memory
The screen displays status and configuration information for the memory
modules installed in your workstation.

Memory Information Example

If a memory card failure is detected during power-on selftest, the following
message is displayed on the console (after completing all selftests) and the
autoboot/autosearch process is automatically stopped:
WARNING: One or more memory banks were not configured due
to a SIMM size mismatch or a SIMM failure. For
more details, use the MEMORY command in the
INFORMATION menu.
The above condition occurs only after the testing and successful
configuration of at least one memory card.
Displaying the Current Memory Configuration
The Boot Console Interface
A-23