Heat Sink - HP 210 G1 Maintenance And Service Manual

6. Remove the system board (3) by sliding it up and to the left an angle.
Reverse this procedure to install the system board.

Heat sink

Description
HP 210 G1 Notebook PC
HP Pavilion TouchSmart 11 Notebook, HP Pavilion 11 Notebook, or HP 215 G1 Notebook PC
computer models
Before removing the heat sink, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Service door (see
b. Hard drive (see
c. Display assembly (see
d. Bottom cover (see
Battery on page 40), and then remove the following components:
Service door on page
Hard drive on page 42)
Display assembly on page
Bottom cover on page
41)
53)
61)
Component replacement procedures
Spare part number
761242-001
730902-001
73