Multibay Ii Eject Assembly - HP Compaq 6910p Maintenance And Service Manual

MultiBay II eject assembly

Description
MultiBay II eject assembly
Before removing the MultiBay II eject assembly, follow these steps:
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
1.
computer on, and then shut it down through the operating system.
Disconnect all external devices connected to the computer.
2.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
3.
then unplugging the AC Adapter from the computer.
Remove the battery (see
4.
Remove the following components:
5.
Hard drive (see
a.
Bluetooth module (see
b.
MultiBay II device (see
c.
Keyboard (see
d.
Switch cover (see
e.
Fan assembly (see
f.
Heat sink (see
g.
Display assembly (see
h.
Top cover (see
i.
Smart card reader board (see
j.
Microphone (see
k.
Speaker assembly (see
l.
m. System board (see
Remove the MultiBay II eject assembly:
Remove the Phillips PM2.0×6.0 screw (1) that secures the MultiBay II eject assembly to the base
1.
enclosure.
88 Chapter 4 Removal and replacement procedures
Battery on page 42).
Hard drive on page 46)
Bluetooth module on page
MultiBay II device on page
Keyboard on page 57)
Switch cover on page
Fan assembly on page
Heat sink on page 67)
Display assembly on page
Top cover on page 76)
Smart card reader board on page
Smart card reader board on page
Speaker assembly on page
System board on page
48)
56)
64)
66)
71)
79)
82)
83)
Spare part number
446434-001
79)