Switch Cover - HP EliteBook 8730w Maintenance And Service Manual

Switch cover

Description
Switch cover (includes LED board and cable and power button board)
Before removing the switch cover, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the keyboard (see
Remove the switch cover:
1. Turn the computer upside down, with the rear panel toward you.
2. Remove the three PM2.0×3.0 broadhead screws that secure the switch cover to the computer.
3. Turn the computer right-side up, with the front toward you.
4. Open the computer as far as possible.
5. Lift the left and right sides of the switch cover to release it from the computer (1).
6. Release the ZIF connector to which the LED board cable is connected (2) and disconnect the cable
from the system board.
Battery on page 41).
Keyboard on page 55).
Spare part number
493986-001
Component replacement procedures 59