Connect The Extender With Wps To A Wifi Network - NETGEAR EX6200 User Manual

Connect the Extender with WPS to a WiFi Network

The easiest way to connect the extender to a WiFi network is by using Wi-Fi Protected Setup
(WPS). For this method to be successful, your WiFi router must support WPS.
If your WiFi router does not support WPS, see one of the following sections:
• Access the Extender over WiFi and Use Smart Setup
• Access the Extender over Ethernet and Use Smart Setup
WPS lets you join a secure WiFi network without typing the network name and password.
The WPS button is a physical button on the rear panel of the extender. Your WiFi router might
have a physical WPS button, a software WPS button, or both.
WPS does not support WEP network security. If you are using WEP security, follow the
instructions in Access the Extender over WiFi and Use Smart Setup

To connect the extender with WPS to a WiFi router and find the best location for the
extender:
1. Place the extender close to the WiFi router.
Note: In a later step in this procedure, after you have established a connection
to the WiFi router, you can place the extender at its permanent location.
2. Plug the extender into an electrical outlet.
3. If necessary, press the Power button.
The Device to Extender LED and the two Link Rate LEDs light amber during the startup
process. After about one minute, these LEDs turn off.
You are now ready to connect the extender to your WiFi router.
4. Press the WPS button on the rear panel of the extender.
Both Link Rate LEDs
minutes.
5. Within two minutes, press the WPS button on your WiFi router.
After a few seconds, the extender connects to your existing WiFi network. Because you
placed the extender close to the WiFi router, the 2.4 GHz Link Rate LED on the extender
lights green, indicating a good connection between the WiFi router and the extender.
If the 2.4 GHz Link Rate LED does not light green, try
does not light green, see
6. If your WiFi router supports the 5 GHz band (not all routers do), and you want to extend that
band, repeat Step 4
confirm the connection.
7. Now that the extender is connected to the WiFi router, move it to a location where you can
boost your WiFi range.
The location you choose must be within the range of your existing WiFi router network.
AC1200 WiFi Range Extender
and the Device to Extender LED
Access the Extender over WiFi and Use Smart
and Step 5 and check that the 5 GHz Link Rate LED lights green to
Get Started
17
on page 19
on page 27
on page 19.
blink green for two
Step 4 and Step 5 again. If it still
Setup.