York YLHA 50 User Manual page 8

1 User manual
1.1 General description of the unit
Antivibratory supports
Whenever necessary to reduce vibrations and noise
produced by the unit to a maximum, a set of steel
spring antivibratory supports can be used. These
should be installed between the chassis support of the
unit and the base or floor on which it is to sit.
This base must be solid and dimensioned in accord‐
ance with the load to be supported.
The antivibratory support accessory for models YL‐
CA/YLHA 40, 50 and 60 includes 4 units, whereas for
models YLCA/YLHA 80, 100, 120 and 150 includes 6.
These spring supports should be distributed and fas‐
tened in the drilled holes at the base of the chiller, the
location of which is detailed in the General Dimen‐
sions section.
6