HP 6000 Service Manual page 57

Component
Doors, docking
Doors, PCMCIA
Heatsink (with fan)
Keyboard
Panel, sound/IR
Panel, mini-PCI
Panel, vent (Omnibook
6000 models only)
HP Omnibook 6000/6100
Removal Procedure
Plug-in module (page 2-5).
Hard disk drive (page 2-7).
Power button panel
(page 2-11).
Keyboard (page 2-15).
Heatsink (page 2-17).
Display assembly
(page 2-13).
Top case (page 2-20).
Plug-in module (page 2-5).
Hard disk drive (page 2-7).
Power button panel
(page 2-11).
Keyboard (page 2-15).
Heatsink (page 2-17).
Display assembly
(page 2-13).
Top case (page 2-20).
See page 2-17.
See page 2-15.
Plug-in module (page 2-5).
Hard disk drive (page 2-7).
Power button panel
(page 2-11).
Keyboard (page 2-15).
Heatsink (page 2-17).
Display assembly
(page 2-13).
Top case (page 2-20).
Plug-in module (page 2-5).
Hard disk drive (page 2-7).
Power button panel
(page 2-11).
Keyboard (page 2-15).
Heatsink (page 2-17).
Display assembly
(page 2-13).
Top case (page 2-20).
Plug-in module (page 2-5).
Hard disk drive (page 2-7).
Power button panel
(page 2-11).
Keyboard (page 2-15).
Heatsink (page 2-17).
Display assembly
(page 2-13).
Top case (page 2-20).
Additional Steps
See the figure on page 2-27.
See the figure on page 2-27.
Reassembly Notes: Make sure the volume control is
oriented properly (pins facing inward). Insert the tabs
on the ends of the panel into the slots in the bottom
case.
On the rear of the computer, remove the screw at the
far left end (nearest the mini-PCI panel).
Omnibook 6000: Detach the cables from mini-PCI
card and motherboard.
Omnibook 6100: Remove the motherboard (page
2-28), then detach the cables.
Reassembly Notes: Insert the pin on the back end of
the panel under the bracket on the bottom case, and
the tabs on the ends of the cover into the slots in the
bottom case.
Removal and Replacement 2-35