Replacing Small Parts (User-Replaceable); Table 2-4. Replacing Small Parts (User-Replaceable) - HP 6000 Service Manual

Replacing Small Parts
(User-Replaceable)
The user can replace the following small parts.
Part
Cap, pointing stick
Bumpers, display (on
display bezel)
Cover, mini-PCI
Cover, SDRAM
Covers, screw (on
display bezel)
Covers, left/right
corner
Feet, rubber (on
bottom of unit)
2-12 Removal and Replacement

Table 2-4. Replacing Small Parts (User-Replaceable)

Replacement Procedure
Pull the cap off the pointing stick.
Insert a small flat-blade screwdriver under the bumper and pry it loose. To replace,
firmly press the adhesive side of the bumper into the recess.
On the bottom of the computer, loosen the screw in the mini-PCI cover (the cover
retains the screw) and remove the cover.
On the bottom of the computer, loosen the one or two screws in the SDRAM module
cover (the cover may retain the screws) and remove the cover.
Insert a small flat-blade screwdriver under the cover and pry it loose. To replace,
firmly press the adhesive side of the cover into the recess.
From the bottom of the computer, remove the screws holding the corner covers, then
remove the covers.
Insert a small flat-blade screwdriver under the foot and pry it loose. To replace, firmly
press the adhesive side of the foot into the recess.
HP Omnibook 6000/6100