Optical Drive Connector Cable - HP Compaq Presario CQ43 Maintenance And Service Manual

Optical drive connector cable

NOTE: The optical drive connector cable is included in the Cable Kit, spare part number
645968-001.
Before removing the optical drive connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
●
WLAN module (see
●
Keyboard (see
●
Top cover (see
●
Speakers (see
●
USB board (see
●
Power connector cable (see
●
Display assembly (see
●
System board (see
Remove the optical drive connector cable:
1. Release the optical drive cable from the clips (1) built into the base enclosure.
2. Remove the two Phillips PM2.0×5.0 screws (2) that secure the optical drive connector to the
base enclosure.
76 Chapter 4 Removal and replacement procedures
Battery on page 41), and then remove the following components:
WLAN module on page
Keyboard on page 51)
Top cover on page 54)
Speakers on page 61)
USB board on page 63)
Power connector cable on page
Display assembly on page
System board on page
42)
64)
66)
73)