Show Basic-Rate - HP 530 Management Manual

Command Line Reference
Wireless Interface Commands
ProCurve Access Point 530(config)# radio 1
ProCurve Access Point 530(radio1)# wlan 1
ProCurve Access Point 530(radio1-wlan1)# show wlan1
------------------------------------------------------------
WLAN # 1 on Radio 1
Description Radio 1 - WLAN 1
Status Enabled
VLAN 1
DTIM Period 2
Security Type no-security (No Sec.)
MAC Auth Mode local deny-list only
Authentication open-system only
WEP Key 1 akshjsnensitk
WEP Key 2 not set
WEP Key 3 not set
WEP Key 4 not set
WPA or WPA2 WPA and WPA2
WPA Pre-auth. Disabled
WPA ASCII Key abcdefghijklmnop
WPA Hex Key not set
Web Authentication
Status
Username/Password Login
Redirect URL
Default Login Page
Default Login Failed Page
Default Welcome Page
-- MORE --, next page: Space, next line: Enter, quit: Control-C
9-122
Example: show wlan1
- Untagged
Disabled
Enabled
www.procurve.com
Enabled
Enabled
Enabled
Related Commands
show ssid (page 9-118)

show basic-rate

This command displays information about advertised transmission rates for
this device.
Syntax
show basic rate
Default
N/A
SSID SSID 1
BSSID 00:14:C2:A7:11:A0
Closed System
MAC Auth List
WEP Key Type
WEP Key Size
Default Key
WPA Cipher
WPA Key Format
Retry Limit
Guest Login
Disabled
not set
ascii
128bit
WEP Key 1
TKIP only
ascii
3
Enabled