Wireless Interface Commands - HP 530 Management Manual

Wireless Interface Commands

The commands described in this section configure global parameters for the
wireless interface.
Command
radio < 1 | 2 >
ssid <ssid>
description
closed-system
mode<value>
antenna < external |
internal >
antenna mode< diversity |
single >
basic-rate<value>
supported-rate<value>
channel-policy < static |
auto >
beacon-interval <interval> Configures the rate at which beacon frames
dtim-period
max-stations
preamble
[no] protected-mode
Function
Enters wireless interface configuration mode. GC
Sets SSID string.
Specifies a human-readable description of this
interface.
Closes access to stations without a pre-
configured SSID.
Sets the radio working mode.
Sets the antenna on this radio.
Sets the antenna mode.
Configures the maximum data rate at which the
access point can transmit traffic.
Configures the maximum data rate at which the
access point can transmit traffic.
Sets the policy on the channel to static or
automatic.
are transmitted from the access point.
Configures the rate at which stations in sleep
mode must wake up to receive broadcast/
multicast transmissions
Configures the maximum number of stations
that can be associated with the access point
at the same time
Sets the length of signal preamble.
Sets the 802.11 b/g CTS protection mode for this
radio.
Command Line Reference
Wireless Interface Commands
Mode Page
9-102
IC-R 9-103
IC-R 9-104
IC-R- 9-104
WLAN
IC-R 9-105
IC-R 9-106
IC-R 9-106
IC-R 9-107
IC-R 9-108
IC-R 9-108
IC-R 9-109
IC-R 9-110
IC-R 9-111
IC-R 9-111
IC-R 9-112
9-101