Cli: Displaying Snmpv3 Settings - HP 530 Management Manual

To create an SNMPv3 user with MD5 authentication, add the auth parameter
and password to the definition.
ProCurve Access Point 530(config)# snmpv3 user-name tjames
auth md5 12345678
ProCurve Access Point 530(config)#
To create an SNMPv3 user with MD5 authentication and AES privacy, add the
auth md5 and priv aes parameters and their passwords to the definition.
ProCurve Access Point 530(config)# snmpv3 user-name ltulina
auth md5 12345678 priv aes 87654321
ProCurve Access Point 530(config)#

CLI: Displaying SNMPv3 Settings

CLI Commands Used in This Section
Command Syntax
show snmpv3
To display all SNMPv3 settings from the Manager Exec level, use the show
snmpv3 command.
ProCurve Access Point 530# show snmpv3
SNMPv3: Enabled
SNMP engine ID: 00:00:00:0b:00:00:00:14:c2:a5:09:8c
SNMPv3 user accounts:
Username Auth. Protocol
----------------------------------------------
ltulina MD5
afanto None
tjames MD5
ProCurve Access Point 530#
General System Configuration
Privacy Protocol
AES
None
None
Configuring SNMPv3
CLI Reference Page
9-47
5-43