Cli: Enabling & Disabling Snmpv3 - HP 530 Management Manual

Figure 5-8. The SNMP - Settings Tab
To Enable SNMPv3:
1. Click Management > SNMP and select the Settings tab.
Click the SNMPv3 Enabled button.
2.
3. Click [Update].
To Disable SNMPv3:
1. Click Management > SNMP and select the Settings tab.
Click the SNMPv3 Disabled button.
2.
Click [Update].
3.
CLI: Enabling & Disabling SNMPv3
CLI Commands Used in This Section
Command Syntax
[no] snmpv3 enable
General System Configuration
Configuring SNMPv3
CLI Reference Page
9-46
5-39