Figure 5-4. Configuring IP Settings
To Enable the DHCP Client i:
1.
Select Network Setup > Ethernet.
2.
To configure the VLAN (untagged), enter a value in the VLAN field.
3.
To set the mode and speed of data transmission, select Speed/Duplex in
the drop-down.
To set a dynamic connection, select DHCP in the Connection Type drop-
4.
down.
5.
Select [Update] to save the DHCP settings.
To Configure IP Settings Manually:
1.
Select Network Setup > Ethernet.
2.
To configure the VLAN (untagged), enter a value in the VLAN field.
To set the mode and speed of data transmission, select Speed/Duplex in
3.
the drop-down.
To set a manual connection, select Static IP in the Connection Type drop-
4.
down.
5.
If you chose Static IP, the IP address and subnet mask auto populates with
the system defaults. You can manually enter a new IP address and subnet
mask in the Static IP Address and Subnet Mask fields. These are required
fields.
General System Configuration
Configuring Ethernet Settings
5-21