HP Compaq 8710p Maintenance And Service Manual page 68

4. Remove the battery (see
5. Remove the memory module/WLAN module compartment cover (see
on page
Remove the WLAN module:
1. Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module.
NOTE:
The white WLAN antenna cable is connected to the WLAN module "Aux" terminal. If the
computer is equipped with an 802.11a/b/g/n WLAN module, the yellow WLAN antenna cable (2)
is connected to the middle terminal on the WLAN module.
2. Remove the two Phillips PM2.0×3.0 screws (3) that secure the WLAN module to the computer.
(The edge of the module opposite the slot rises away from the computer.)
3. Remove the WLAN module (4) by pulling the module away from the slot at an angle.
NOTE:
Reverse this procedure to install the WLAN module.
58 Chapter 4 Removal and replacement procedures
Battery on page
54).
The black WLAN antenna cable is connected to the WLAN module "Main" terminal.
WLAN modules are designed with a notch (5) to prevent incorrect installation.
46).
Primary memory module