Firmware Update Instruction Manual This manual explains the procedures for downloading the GR DIGITAL III firmware from the Ricoh website and updating the camera’s firmware. Perform the following operations to update the firmware. 1. Check the current version of the firmware Caution Before updating, be sure to check the firmware version through the following method.
Page 2
2. Extract the firmware Download the firmware from the Ricoh website. Double-click, or right-click and select [Open] on the downloaded file. • A dialog screen appears. Click [OK]. • The folder [GR DIGITAL 3 Update] is created, and the firmware is extracted to the folder [Firmware relX.XX (where X.XX is the version number)].
Select [Yes], and press the MENU/OK button. • The SD memory card is formatted. Caution If you format a card that still has images stored on it, the images will be lost. Save the images you do not want to erase in your computer before formatting the card.
Page 4
Click the [Close] button. Turn the camera off, and disconnect the USB cable. To copy the firmware using a card reader or a card writer to an SD memory card Load the SD memory card into the camera, and turn the power on. Display the camera’s setup menu tab, select [Format [Card]], and press the $ button.
4. Update the firmware Make sure that the camera’s power is turned 6 ( 2 ) off. While pressing the ! button ( 1 ), hold down the 6 (Playback) button ( 2 ) for 2-3 seconds. • A confirmation message for the firmware update is ! ( 1 ) displayed on the picture display.