Playing back images on a computer (pictures/movies) (38 pages)
Summary of Contents for Ricoh CX2
Page 1
Firmware Update Instruction Manual This manual explains the procedures for downloading the CX2 firmware from the Ricoh website and updating the camera’s firmware. Perform the following operations to update the firmware. 1. Check the current version of the firmware Caution Before updating, be sure to check the firmware version through the following method.
Page 2
• A dialog screen appears. Click [OK]. • The folder [CX2 Update] is created, and the firmware is extracted to the folder [Firmware relX.XX (where X.XX is the version number)]. Check that [hlaunch3] (firmware file) and [hlaunch8] (adjusted value file) are inside the folder [Firmware relX.XX].
Select [Yes], and press the ADJ./OK button. • The SD memory card is formatted. Caution If you format a card that still has images stored on it, the images will be lost. Save the images you do not want to erase in your computer before formatting the card.
Page 4
Click the [Close] button. Turn the camera off, and disconnect the USB cable. To copy the firmware using a card reader or a card writer to an SD memory card Load the SD memory card into the camera, and turn the power on. Display the camera’s Setup menu, select [Format [Card]], and press the ADJ./OK button F.
4. Update the firmware Make sure that the camera’s power is turned off. While pressing the ADJ./OK button ! (1), hold down the 6 (Playback) button (2) for 2-3 seconds. • A confirmation message for the firmware update is displayed on the picture display.