Series 3 Hopper Assembly - Louisiana Grills CS 450 Owner's Manual

INSTALLING THE HOPPER & IGNITER
Parts Included:

Series 3 Hopper Assembly

Mounting hardware
2 x #10 x 16 x1/2" screws,
4 x 1/4 x 20 x 1/2" screws
Tools Required:
Phillips & Standard
Screwdrivers
Installation:
Step 1 Attaching the Igniter to the hopper:
Carefully remove the igniter and its packaging from inside
the hopper. Diagram A
Using your 1/4" nut driver and the 2 (two)
#10 x 16 x 1/2" Dritap screws, secure the Igniter
to the outside of the hopper.
Step 2 Attaching the hopper to the barrel:
Carefully lift the entire hopper and attached igniter, to the left hand
side of the main barrel.
The mounting bracket on the rear of the hopper (C) must be raised
slightly higher then the receiving bracket on the barrel.(D)
Diagram C & D
Begin by slightly inserting the igniter into the installed Burned Pot
at the bottom side of the barrel.
Next slightly insert the Auger Feed tube into the correct hole.
. It might be necessary to raise the hopper slightly to ensure the
mounting bracket on the hopper will go over the receiving
bracket on the barrel.
Push Hopper tightly against the main barrel.
Next holding the hopper fairly level, press downward to clip the
hopper onto the mounting bracket. Diagram C & D
Using your 5/16" nut driver or standard screwdriver and the
4 1/4x20-1/2" hex screws, secure hopper to barrel through
the holes provided, inside the barrel.
NOTE: If the holes do not line up,
the hopper may need to
be fully clipped into place.
Assembly Instruction
1/4" Hex Nut Driver,
5/16" Hex Nut Driver
Phillips Screw Driver &
Cordless Drill
Diagram B
Diagram C
Diagram E
A
B
C
D
E