Accu-Chek Compact Plus User Manual page 63

Each digit is represented by the corresponding number of beeps; e.g. 4
beeps for the number 4 ( – – – – ). Zero is represented by a long beep
( — ).
The result is announced three times in succession. Each result is pre-
- -
ceded by two short beeps ( ) . Altogether, therefore, you hear:
result - - result - - result.
mmol/L meters
First the tens are announced, then the units, then the decimal point and
finally the tenths. There is a short pause between each group of beeps.
The tens are always announced, even when the result is below 10. The
tens in this case are represented by 1 long beep, signifying zero. The
decimal point is represented by 1 very short beep ( . ).
Examples:
The result 13.8 mmol/L is announced as follows:
1 beep – pause – 3 beeps – pause – 1 very short beep – pause– 8
beeps
.
( – – – – – – – – – – – – )
The result 4.0 mmol/L is announced as follows:
1 long beep (for 0 tens) – pause – 4 beeps – pause – 1 very short
beep – pause – 1 long beep
.
( — – – – – — )
124
mg/dL meters
First the hundreds are announced, then the tens, and finally the units.
There is a short pause between each group of beeps. The hundreds are
always announced, even when the result is below 100. The hundreds in
- -
this case are represented by 1 long beep, signifying zero.
Examples:
The result 180 mg/dL is announced as follows:
1 beep – pause – 8 beeps – pause – 1 long beep
( –
The result 72 mg/dL is announced as follows:
1 long beep (for 0 hundreds) – pause – 7 beeps – pause – 2 beeps
( —
Results that are lower than 0.6 mmol/L or 10 mg/dL and are displayed
as
0 – 0 – 0, respectively.
Results that are higher than 33.3 mmol/L or 600 mg/dL and are dis-
played a
9 – 9 – 9, respectively.
Acoustic Mode Acoustic Mode
– – – – – – – – — )
– – – – – – – – – )
are announced acoustically as 0 – decimal point – 0 and
are announced acoustically as 9 – 9 – decimal point – 9 and
6
125