HP 3105m Maintenance And Service Manual page 56

3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the service cover (see
6. Remove the hard drive (see
7. Remove the keyboard (see
8. Remove the top cover (see
NOTE: Before removing the ClickPad TouchPad, it is necessary to remove the ClickPad TouchPad
button board bracket.
Remove the ClickPad TouchPad button board bracket:
To remove the ClickPad TouchPad button board bracket, follow these steps:
1. Position the top cover upside down, with the front toward you.
2. Remove the four screws that secure the ClickPad TouchPad button board bracket to the top
cover (1).
3. Lift up and remove the ClickPad TouchPad button board bracket (2).
Reverse this procedure to install the ClickPad TouchPad button board bracket.
Remove the ClickPad TouchPad button board:
48 Chapter 4 Removal and replacement procedures
Battery on page 32).
WLAN module on page
Hard drive on page
Keyboard on page 43).
Top cover on page 45).
39).
33).
ENWW